		Windows95 Using Hyperterminal
		Windows95 Using Hyperterminal

Setup

    Select "Start-Programs-Accessories-Hyperterminal"
    Double Click on "Hypertrm"
    Enter name eg. "direct1", then "OK"
    Set "Connect using:" to "Direct to Com1", then "OK"
	
	    Set "Bits per second:" to "9600"
	    Set "Data bits:" to "8"
	    Set "Parity:" to "None"
	    Set "Stop bits:" to "1"
	    Set "Flow control:" to "none"
	    Select "OK"
	

Now press reset on the Monitor board. If you
don't see a banner message from PMON/IMON you might need a special cable.

If you get dropped characters when displaying some commands (eg "r"),
you probably need to enable the 16550 buffer. Select
File-Properties-Configure-Advanced and make sure that the FIFO
buffers are enabled. Note that you must Disconnect and Connect the Call
before this change will take effect.

If the command-line editing characters ^A, ^B etc. don't work, change
Propeties-Settings to vt100.

Sending Files

To send a text file to the target, perform the following steps:

    PMON load
    Hyperterminal
	
	    Select "Transfer-Send Text File"
	    Use Browser to select directory
	    Set "Files of type:" to "All files"
	    Select the .rec file, then "Open"
	


Navigation: 
Document Home | 
Document Contents | 
Document Index 

**This file was converted from HTML to TEXT using a TRIAL version of**
**Markup Remover 1.1 (C) 1998 by Aquatic Moon Software http://www.aquaticmoon.com/**
**This message does not appear in files converted after the program has been liscensed.**
